Modelling waves and billows in just a few steps
The product Waves & Billows is a paste-like mass that is spread over the dried surface of the water with a small putty knife or scraper.
![](https://noch.b-cdn.net/media/44/36/3a/1697524156/RS12939_Basteltipp_Slider_416x800.png?width=3000)
After the mass has dried for about half an hour, it’s tough enough for creating higher billows. Beautiful waves and water forms can be created with a toothpick or a small putty knife.
If you want to model higher waves that break on the shore area, for example, the mass is first pushed towards the shore with a bristle brush.
If you want to model higher waves that break on the shore area, for example, the mass is first pushed towards the shore with a bristle brush.
To erect the wave, the material must first dry a little and form a stabilising skin. Then erect the mass into the shape of a cockscomb. You might have to repeat this process until the wave stands securely and can harden. The material will harden and dry transparent after approx. 12–18 hours.